Search results

Hey guys. Its been great running into some of you at local shows this season. Im looking at doing a mild head swap on my motor. Its a carb'd 306 with a b cam currently has e6 heads :nono:. Im interested in a set of gt40p heads and was wondering what you all thought. I was just wondering a...

Only a 15 minute drive for me.... Ill be there.

Not sure really where to post this soooo... I figured it would be cool to let people know where some good driving/ cruising roads are all over this great state of ours. Being from Orange County Ill start by adding some from Southern NY 218 in Cornwall/ West Point Perkins Drive, Bear Mtn...

Im looking to finish the project im currently doing and dont need any of the following parts i have. Switched to carb so all these parts are now useless to me. Upper Intake w/ Throttle Body Lower Intake w/ fuel rails, lines, 24 lb injectors, injector harness and fuel lines going down the...

Hey i was just wondering what size bolts are needed to install headers. I bought a set of mr gasket bolts to install MAC shorties but im not sure if they are the correct dimensions.

Hey im putting a carbed v8 into my fox and was wondering how i would be able to run the least amount of accesories on the engine. I would like to run only the crank, water pump and alternator pullies. What eliminator brackets if any would i need. I know that if i ran just the one belt to each...

Also does anyone have a spacer plate for a t-5? I have one for an auto. Will that work with the t-5 bellhousing, flywheel and starter? THanks

Hey guys im in the process of doing a 4-8 swap and am going carb. I still have quite a few parts that i need before the project will be complete. In no particular order: Any MSD Ignition parts, Dizzy for Carb, 6AL Box, Blaster SS Coil Exhaust Pieces, Headers Shorties or LTs, Offroad...

Just a question guys.... Im doing a project right now and dont care about power steering and want to also eliminate the a/c and smog. I figure this just leaves me then with the crankshaft, water pump, and alternator with the tensioner. How would i go about doing this and what eliminator...

Haha nice. I am definately planning on heading to e-town for that swap meet. What is the date of the carlisle meet? Either way i will certainly be at rhineback.

I would but i would probably appear to be more of a ricer in the volvo than a member of the "stang gang" As a matter of fact i really cant wait to see it and i think anyone that denies they want to is lying.... Paul Walker FTW

Just a question.... for the swap meet will i be able to buy any parts for foxes or is it just older cars? Thanks.

Haha ive gone down every wednesday for the past two years with all my high school friends and im sure well all be down to go again this year. Only a 15 minute drive for me and its great to cruise up the mountain after too. Best show around..... Not sure if the mustang will be ready for this...

Im interested in buying any kind of fox mustang parts. On this subject anyone know the date of the Englishtown Mustang swap-meet?

Most likely EFI. I will probably just get a whole motor and harness sometime. My main source of parts is trying to convince me to go carb however. It just doesnt make sense to me to carb a 302. If i was doing a stroker variation i would go carb. I plan on doing another car in the future...

Dont mean to hijack the thread but what are the different computer codes for MAF and speed density? Also is there a different computer for auto and manual cars?

Im new to these boards referred from SVTP. Im in the process of converting a 87 4 Cyl auto to a 302 with a t5. Anybody on here in the Newburgh area?